Data Transformation Engine IBM WebSphere MQ Adapter Reference Guide

Chapter 3 - IBM WebSphere MQ Commands List of Commands
IBM WebSphere MQ Adapter Reference Guide
33
Note Do not try to specify values for these fields if you use the -DH option in the
adapter command. Using that option causes values you provided in these fields to
be ignored by the adapter and replaced with the default IBM WebSphere MQ
values. If you need to explicitly specify values for these fields, use the -HDR
option in the adapter command (without the -DH option).
The Default Header adapter command (
-DH) overrides the Header adapter
command (
-HDR).
Note The appropriate header information must be mapped if the Default Header adapter
command (-DH) is used. If the header information is not mapped and the Default
Header adapter command (-DH) is used, a warning message is generated and the
default MQMD values are used.
Error Queue Manager Name (-EQMN)
Use the Error Queue Manager Name adapter command (-EQMN) for data sources
and data targets to specify the name of the queue manager for the error queue.
-EQMN
error_queue_manager_name
Only use the Error Queue Manager Name adapter command (-EQMN) when the
Error Queue Name adapter command (
-EQN) is specified and you want to
designate a different queue manager for the error queue than the default. The
default queue manager is specified with the Queue Manager Name adapter
command (
-QMN).
Note Only use this adapter command when using the IBM WebSphere MQ Client
adapter; using it with the IBM WebSphere MQ Server adapter causes an error.
This is because only the IBM WebSphere MQ Client application can be connected
to more than one queue manager at the same time.
Error Queue Name (-EQN)
Use the Error Queue Name adapter command (-EQN) for data sources and data
targets to specify the error queue to which messages are copied when errors
occur. If a message has the rollback option set and a map does not successfully
complete, the message is copied to the designated error queue. The original
message is removed from the source queue.
-EQN
error_queue_name