Data Transformation Engine Integration Flow Designer Reference Guide

Chapter 4 - How the Integration Flow Designer Works Theory of Operation
Integration Flow Designer Reference Guide
58
The following illustration shows a map component that has all four target-types
represented.
You can use the IFD to change a map component’s sources or targets by changing
its source or target settings. This capability enables you to reuse the functionality
of a map and couple it to desired source and target pipelines.
Retry and rollback settings are also available for each source and each target. The
retry setting specifies how many attempts will be made to recover from a source
or target fault condition that might occur. These attempts are spaced over a
specified interval of time. The rollback setting specifies whether source or target
data should be rolled back to its original state if the map fails as a transaction
unit.
Map Settings
Map settings are initially defined for a map in the Map Designer. You can use the
IFD to override these map settings. Map settings include definitions for audit log
creation, paging values, trace file creation, validation settings, and work file
configuration.