Data Transformation Engine Integration Flow Designer Reference Guide

Chapter 6 - Map Components Working with Map Components
Integration Flow Designer Reference Guide
86
Map Names
You choose a map component name when adding the component to a system. It is
common to name a map component the same as the executable map that it
references. You can also rename a map component within a system. Duplicate
component names are not accepted within a system.
Execution Settings
This section presents the basic concepts of map component execution settings and
describes the available settings according to the Command or Event Server that
runs the map.
Map components are executable units. Using the IFD, you can specify the
execution settings for a map component, which in turn are used by the Command
Server or Event Server to run the map. Because the IFD treats each component as
a unique instance, these execution settings are maintained separately for each
map component.
Some of the execution settings that you specify are used by both Event Servers
and Command Servers at execution time. Settings that apply to both engines
include the location of the map on the server to be executed, source settings for
input data, target settings for output data, and the same set of map settings
available in the Map Designer.
Viewing Execution Settings
You can define execution settingsfor each map component in your system. There
are two ways to access execution settings.