Data Transformation Engine Integration Flow Designer Reference Guide

Chapter 6 - Map Components Working with Map Components
Integration Flow Designer Reference Guide
92
TimeEvent Setting Description
♦ Minute - The Minute setting is used to specify
how many minutes to wait to begin the map.
The default value for the Minute setting is 0.
♦ Second - The Second setting is used to specify
how many seconds to wait to begin the map.
The default value for the Second setting is 0.
Trigger Use the Trigger setting to define the type of time event
trigger. You can trigger a map based on a singular time
event or cycle, according to a specified time increment.
The default value is Once.
Trigger > Interval Use the Interval setting to describe the recurring period
to use for the trigger. The Interval setting is available
only if the value of the Trigger setting is Every. The
default value for the Interval setting is 1 Day(s).
Interval > At Use the At settings to set a specific time for the trigger to
start after the start of the interval defined in Interval
settings. The At settings are only available if the value of
the Trigger setting is Every. The time periods specified
in the Hour, Minute, and Second settings describe a
time based on a 24-hour clock set to system time.
♦ Hour - The Hour setting specifies the hour in
which to run the map. The default value for the
Hour setting is 0.
♦ Minute - The Minute setting specifies the
minute in which to run the map. The default
value for the Minute setting is 0.
♦ Second - The Second setting specifies the
second in which to run the map. The default
value for the Second setting is 0.
OmitDays Use the OmitDays setting to set the days to omit.
♦ Monday - The Monday setting is used to omit
Mondays from the time trigger schedule. The
default value for the Monday setting is No.
♦ Tuesday through Sunday - These settings
work the same way as the Monday setting.
OmitHours Use the OmitHours setting to set the hours to omit.