Data Transformation Engine Integration Flow Designer Reference Guide

Chapter 6 - Map Components Working with Map Components
Integration Flow Designer Reference Guide
95
Note Refer to the Map Designer Reference Guide or online help for information on how
to configure these settings.
Output Settings
The following table lists output Event Server and Command Server settings.
Output Setting
Command Server
Settings
Event Server
Settings
Backup
√
Target
Command
√ √
OnSuccess
√*
OnFailure
√ √
Retry
√ √*
Warnings
√
Scope
√
*Availability varies by adapter.
Overriding Map Settings
Map settings specify properties for map executions that are not specific to a
particular input or output. Map settings defined during the design phase are saved
in the map source file (.mms) and the compiled map file (.mmc). Using the IFD,
you can override these map settings. Any time you change a map setting from the
IFD, it is considered an override. This override value is used during the creation of
system files for the Event Server or command files for the Command Server.
From the IFD, if you place an override on a map card, the override propagates to
the uppermost system level where that card is visible. When an override is placed
on a subsystem card for the corresponding map card, the higher-level subsystem
card override takes precedence, and is propagated to the top. The override at the
highest level always takes precedence.