Data Transformation Engine Map Designer Reference Guide

Chapter 10 - Map Settings MapAudit Settings
Map Designer Reference Guide
168
BurstAudit > Data
The Data setting is used to include or exclude data information in the audit log.
The burst audit data information includes a burst count, the card number, the
object index, the audit log status code, the object level, the size of the object, and
the object name. You can specify that you want to audit a particular object by
including that object in the Organizer window on the Data Audit Settings tab.
The BurstAudit > Data settings are listed in the following table. The default
setting is Never.
Value Description
Always Write data to the audit log, regardless of the map
execution outcome.
Never Do not log data information.
OnBurstError If the outcome of the execution of the burst meets
a failure condition, write the burst data to the audit
log.
OnBurstWarningOrError If the outcome of the execution of the burst is a
warning or meets a failure condition, write the burst
data to the audit log.
Data > SizeValidation
When BurstAudit > Data is set to Always, OnBurstError, or
OnBurstWarningOrError, the SizeValidation field becomes available. The input
trace file will report when data fails to meet size requirements for the type.
Value Description
TooLong TooShort When you choose this option and the minimum or
maximum size requirements are not met during data
validation, one of the following size-specific messages
will be indicated in the input trace file:
"
fails minimum size requirements"
"fails maximum size requirements"
Wrong Size This is the default option for this setting. If the
minimum or maximum size requirements are not met
during data validation, it will be indicated in the input
trace file with a generic message similar to the