Data Transformation Engine Map Designer Reference Guide

Chapter 18 - Error and Warning Messages Map Execution Error and Warning Messages
Map Designer Reference Guide
273
Return Code Message
17 Disk read error
An attempt may have been made to access a file on a shared
resource that is not accessible. Also, check the amount of available
disk space.
18* Page usage count error
Your data mapped correctly; however, an internal paging problem
exists. Contact Mercator Technical Support.
19 Internal calling error
Contact Mercator Technical Support.
20 Reopen file failed
Your map did not run correctly. Contact Mercator Technical
Support.
21* Input valid but unknown data found
Enough of the input data to conform to the card definition was
recognized, but there was more data at the end of the input
stream. Enable the Trace Input setting, re-run the map and read
the map trace file (.mtr).
22 Page size too small
Increase the page size or decrease the number of types in the
type tree that are used to define the input.
23 Unable to reuse work file
Use the same page settings that were used when you created the
existing work file.
24 Database error
A problem was encountered attempting to write to an output
database. Read the database trace file (.dbl) for information about
possible causes.
25 File attribute error
When running an AS/400 Command Server, if you use the OS/400
data definition to create a file, check the definition of the output
card to see if it matches.