Data Transformation Engine Map Designer Reference Guide

Chapter 18 - Error and Warning Messages Map Execution Error and Warning Messages
Map Designer Reference Guide
274
Return Code Message
26* Output type in error
The entire card object is in error.
27* Output type contains errors
One or more components failed restrictions or a component rule.
28* Input type contains errors
This occurs when mapping data of a component that has a
RESTART assigned to it, and at least one instance of the
component in the input data is invalid.
29* Output valid, but unknown data found
This occurs when enough of the output data is recognized to
conform to the card definition, but there was more data at the end
of the output stream.
30 FAIL function aborted map
This occurs when the FAIL function is used within the map to
cause map execution to cease. The return message specified as
the second argument of the
FAIL function appears in place of the
xxx in the Execution Audit section of the Audit Log. See the
Functions & Expressions Reference Guide for more information
about using the FAIL function.
31 This map requires a Command Server for Japan
This map used Japanese characters and must be executed using a
Command Server for Japan.
32 Invalid map instance handle
Contact Mercator Technical Support.
33 Map instance handle in use
Contact Mercator Technical Support.
34* Too few pages requested, more allocated
The map can complete but it can be better optimized by increasing
the page count.
35 Insufficient number of pages to execute map
The map could not complete because not enough pages were
specified.