Data Transformation Engine Map Designer Reference Guide

Chapter 18 - Error and Warning Messages Map Execution Warning Messages
Map Designer Reference Guide
275
Map Execution Warning Messages
The following table lists the return codes that are warnings only – meaning that
the map did complete, but some problems occurred. You can change the default
behavior for the warning codes by specifying Fail on Warnings or Ignore
Warnings through the map settings or by using the
–F or –Z execution
command.
Note The warning codes marked with an asterisk (*) are returned only when at least
one output is listed in the Data Audit Settings of the Organizer and in the Map
Settings dialog, MapAudit is enabled with Data enabled for the Log setting.
Return Code Message
14 One or more outputs was invalid
A number produced an overflow condition. Enable the Trace
Output option, re-run the map, and read the trace file.
18 Page usage count error
Your data mapped correctly; however, an internal paging problem
exists. Contact Mercator Technical Support.
21 Input valid but unknown data found
Enough of the input data to conform to the card definition was
recognized, but there was more data at the end of the input
stream. Enable the Trace Input setting, re-run the map and read
the map trace file (.log).
26* Output type in error
The entire card object is in error.
27* Output type contains errors
One or more components failed restrictions or a component rule.
28 Input type contains errors
This occurs when mapping data of a component that has a
RESTART assigned to it, and at least one instance of the
component in the input data is invalid.