Data Transformation Engine Map Designer Reference Guide

Chapter 18 - Error and Warning Messages Map Build Error Messages
Map Designer Reference Guide
276
Return Code Message
29* Output valid, but unknown data found
This occurs when enough of the output data is recognized to
conform to the card definition, but there was more data at the
end of the output stream.
34 Too few pages requested, more allocated
The map can complete but it can be better optimized by
increasing the page count.
Map Build Error Messages
Build errors prevent a map from being compiled. If build errors occur, view the
errors, correct the problem(s), and build the map again. A map cannot be run if it
has not been built.
In the following build messages; these letters are used as variables:
x = the map where the error occurred
y = the output that contains the rule in error
w, z = numbers
Words used as variables are in italics. For example, map-name represents the
name of a map.
Return Code Message
M100
Analysis aborted by user.
M101
Map: x
Unresolved rules exist.
Hint: Go to map x. If you want to use the unresolved rules, copy
and paste them. Delete any unwanted unresolved rules.