Data Transformation Engine Map Designer Reference Guide

Chapter 5 - Card Settings SourceRule Input Card Settings
Map Designer Reference Guide
81
The SourceRule card settings and their override execution commands are listed
in the table below:
SourceRule Card
Setting
Override Execution Command
FetchAs Not available
Backup Not available
WorkArea
Available (-W)
Source
Available (-IA), (-ID), (-IE), (-IF), (-IM)
FilePath
Available (-IA), (-ID), (-IE), (-IF), (-IM)
OnSuccess
Available (-I…X)
OnFailure
Available (-I…B)
Retry
Available (-I…XRcount:interval)
Warnings Not available
Scope Not available
FetchUnit Not available
FetchAs
The FetchAs setting on an input card specifies how the data will be retrieved
when the map is executed.
Value Description
Integral Data is retrieved once (in its totality) from the data source. If
another input is set to Burst mode, the same integral data for
this card is used for each burst. When an input FetchAs is
Integral, the Source is requested to retrieve data once for
the entire mapping.