Data Transformation Engine Map Designer Reference Guide

Chapter 5 - Card Settings Input and Output Card Settings
Map Designer Reference Guide
99
Using DocumentVerification for Output Data
For output data, the DocumentVerification option only works if the MapAudit >
SettingsAudit > Data setting is enabled for the output. This is because output
data is only validated (by means of the standard validation process) if the
MapAudit > SettingsAudit > Data map setting for the output is enabled and
the output item is specified under Data Audit Settings in the Organizer as
shown:
If the MapAudit > SettingsAudit > Data map setting is enabled for an output
card, standard data validation occurs during the audit process, and the external
verification program can run when specified.
Backup Settings
The Backup settings, when enabled, control when, where, and how the data for
input and output cards should be copied to a specified backup file.
You can define the Backup settings for each input or output card as needed.
Defining Backup Settings
The Backup settings are defined at the card level. Define the Backup setting for
each input or output card as required. Expand the Backup setting to define the
Switch, When, and BackupLocation, which includes the directory and filename
values.
To define the Backup settings
1 From the Edit Input or Output Card dialog box, locate the Backup setting
and set the Switch to ON.
2 Use the When setting to define under what circumstances a backup file is
created. Select Always or OnError.
3 Under the BackupLocation > Directory setting, specify if you want the
backup data file written to the Map directory or to a Custom directory of your
choice.