Data Transformation Engine Return Codes and Errors Reference Guide

Chapter 4 – Adapters R/3
R/3
The following is a listing of all the codes and messages that can be returned as a
result of using the R/3 adapter for sources or targets.
Note Adapter return codes with positive numbers are warning codes that indicate a
successful operation. Adapter return codes with negative numbers are error codes
that indicate a failed operation.
Return Code Message
0 OK
1 No data provided. Create on content specified: no
connection attempted.
2 Map execution failed, data not sent
-1 Error in data prep
-1 Error: cannot get function definition
-1 RFC Open failed
-1 Put Data failed
-1 Unknown Error
-1 Error in setup
-1 TID sent twice so not processed
-1 R/3 may try again later
-1 Couldn’t init adapter. New_semaphore() failed.
-1 Couldn’t init adapter. Watch count exceeded.
-1 Couldn’t init watchpoint. New_thread() failed.
-1 Error in data prep (invalid Idocs).
-1 Error in data prep (invalid BAPI data or Idoc
missing EDI_DC)
-1 Connection Test failed
-1 Connection Test not possible, handle is invalid
-1 RFC Accept Failed
-1 Install Function Failed
-1 InitRfcConn Failed