Data Transformation Engine Return Codes and Errors Reference Guide

Chapter 5 – Maps Map Compile Error Messages
Return Code Message
M1013 Could not retrieve database information.
Hint: Either you have not installed the Database Interface
Designer or the .mdq file is incorrect.
M1014 Input data file for executable map missing or
invalid.
Hint: Check the file names used for sources and targets.
M1015 Output data file for executable map missing or
invalid.
Hint: Check the file names used for sources and targets.
M1016 Parser found an invalid rule.
Hint: If you get this error, please contact Technical Support.
M1017 Output card referenced in rule not found.
Hint: If you get this error, please contact Technical Support.
M1018 Invalid component or partition subtype encountered.
Hint: If you get this error, please contact Technical Support.
M1019 Unable to resolve type references in rule.
Hint: If you get this error, please contact Technical Support.
M1020 Couldn’t open the compiled map file.
Hint: The compiled map file may be corrupt. Please contact
Technical Support.
M1021 Error writing to the compiled map file. (Disk
full?)
Hint: Delete unnecessary files from your hard disk.
M1022 Unable to resolve type references in audit.
Hint: If you get this error, please contact Technical Support.
M1023 Unable to open .MDQ file.
Hint: The .mdq file does not exist or is otherwise inaccessible.
M1024 Database not found.
Hint: The named database is not defined in the specified .mdq
file.