Data Transformation Engine Type Tree Maker Reference Guide

Type Tree Maker Reference Guide
22
Chapter 4 - Commands and Command
Elements
This chapter describes the Type Tree Maker commands and command elements.
Command Descriptions
This section contains an alphabetical list of commands.
Note In a Type Tree Maker document file, command components appear on the same
line as the command in which they are contained to make it easier to identify an
error detected by the Type Tree Maker. In the following examples, components
may appear on separate lines for documentation only.
AddComponent
The AddComponent command adds a component to the group specified as the
active type.
The component is added as the last component in the component list of the active
type. If the active type is an item, the AddComponent command is ignored and
an error message is written to the error file.
See the Type Designer Reference Guide for information on specifying component
rules.