DCE Installation, Configuration, and Management Guide

Configuring NonStop DCE
HP NonStop DCE Installation, Configuration, and Management Guide—429552-005
4-10
Configuring DCED as Endpoint Mapper
To configure a DTS server:
1. Select dce_config option 3 (Initial DTS Server) from the Initial Cell Configuration
menu. This menu is displayed:
2. Select the option for the type of demon desired.
Time-service principals are added to the security registry and the time-service demon
dtsd is started.
If there are fewer than three DTS servers in the cell, warning messages appear at the
end of DTS configuration. These warning messages can be prevented by executing
the following dcecp command before running dce_config:
dts modify -minservers number-of-servers-in-cell
You can now continue with the procedure described in Configuring DCED as Endpoint
Mapper.
Configuring DCED as Endpoint Mapper
Repeat this procedure for each virtual host in the cell:
1. From the initial cell configuration menu, select option 4 (DCED as Endpoint
Mapper) . This prompt is displayed:
Do you wish to first remove all remnants
of previous DCE configurations for all components (y/n)? You
should do so only if you plan on reconfiguring
as a client of a different cell: (n)
2. Enter y.
This prompt appears:
Enter the name of your cell (without /.../):
3. Enter the desired cellname. For example, cellname. Subsequently, the name
/.../cellname or the shorthand /.: is used to refer to this cell.
This prompt appears:
Enter the name of the DCE privuser: (SUPER.SUPER)
DTS Configuration Menu
1. DTS Local Server
2. DTS Global Server (needed only in multi-LAN cells)
3. DTS Clerk
4. DTS Time Provider
5. UNINSTALL -uninstall self DCE host
98. Return to previous menu
99. Exit
selection: