DCE Installation, Configuration, and Management Guide

dce_config(8) Reference Page
HP NonStop DCE Installation, Configuration, and Management Guide—429552-005
B-5
CELL_NAME Specifies the name of the cell (without the /../) on
which the configuration is being performed. Used
during security server configuration.
check_time Specifies whether to check client and server clock
synchronization. (All lowercase characters is
correct.)
The value y indicates the time will be checked; n
indicates it will not.
The default value is y.
CLONE_FROM Specifies the name of the virtual host to be used
when cloning is performed. This variable is ignored
unless CLONING_REQUIRED is set to y. If
CLONING_REQUIRED is set to y, then
CLONE_FROM must specify the name of a virtual
host that is already installed.
CLONING_REQUIRED Specifies whether binary files of another virtual host
should be shared (cloned).
The value y indicates that cloning should occur; n
indicates that it should not.
The default value is n.
COPY_CONFIG_HOST Specifies the name of the virtual host to be used
when copying for replica servers is performed. This
variable is ignored unless COPY_CONFIG_INFO is
set to y. If COPY_CONFIG_INFO is set to y, then
COPY_CONFIG_HOST must specify the name of a
virtual host that is already installed.
COPY_CONFIG_INFO Specifies whether the configuration should be
copied from another virtual host. Copying implies
that an additional CDS or security server is being
configured to be a replica of the virtual host named
by the COPY_CONFIG_HOST environment
variable.
The value y indicates that copying should occur; n
indicates that it should not.
The default value is n.
CPU_LIST Specifies the processors to be used by the virtual
host being configured.
Processor numbers must be separated by one or
more spaces and the list of numbers must be
enclosed in quotation marks. If a specified
processor is down or not available, the system
allocates a replacement processor.
Table B-1. dce_config Environment Variables (page 2 of 9)
Variable Value