DCE Installation, Configuration, and Management Guide

dce_config(8) Reference Page
HP NonStop DCE Installation, Configuration, and Management Guide—429552-005
B-10
REMOVE_PREV_INSTALL Indicates whether to remove all remnants of
previous DCE installations before performing the
new install.
The value y indicates remove all remnants; n
indicates do not remove remnants.
The default value is n.
If you set this variable to y, dce_config
automatically removes all installed components
each time you install any component, and you must
reinstall them all. Used in all component
installations.
REP_CLEARINGHOUSE Specifies the name for a new clearinghouse. Used
in additional CDS server configuration.
REPLICATE_ALL_DIRS Specifies whether to replicate all directories from
the master CDS server database to the additional
CDS server database during additional CDS server
configuration.
The value y indicates that all directories should be
replicated.
The value n indicates that no directories should be
replicated.
The default value is n.
REPLICATE_DIR_LIST Specifies a list of directories to be replicated.
Directory pathnames must be separated by one or
more spaces and the list of directories must be
enclosed in quotation marks. For example, if the
directory to be replicated is /.:/test_dir, set the
variable to "test_dir".
If this variable is not specified, the user is prompted
for a directory list.
SEC_REPLICA Specifies the name of the security replica database.
The default value is the name of the host being
configured.
SEC_SERVER Specifies the hostname of the machine on which
the cell’s master security server runs. Used in
security client configuration.
SEC_SERVER_IP Specifies the IP address for server named in
SEC_SERVER.
Table B-1. dce_config Environment Variables (page 7 of 9)
Variable Value