Debug Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction
- Execution Modes on TNS/R Systems
- What User Access Is Required for Debugging
- How to Make a Process Enter Debug
- How to Select Debug as the Debugger
- Why a Process Enters Debug
- How to Determine Process State on a Trap or Signal
- Ending a Debug Session
- What Appears in the Debug Header Message
- How to Use Debug
- How Debug Breakpoints Work
- 2 Using Debug on TNS/R Processors
- 3 Debug Command Overview
- 4 Debug Commands
- Command Summary
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command (TNS/R Native and OSS Processes)
- INSPECT Command
- LMAP Command
- M Command
- MH Command (TNS/R Native and OSS Processes)
- P[AUSE] Command
- PMAP Command (Accelerated Programs)
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- A Error Messages
- B ASCII Character Set
- C Command Syntax Summary
- Register Syntax
- Expression Syntax
- Address Syntax
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command
- INSPECT Command
- LMAP Command
- M Command
- MH Command
- Output-Device Syntax
- P[AUSE] Command
- PMAP Command
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- D Session Boundaries
- E Correspondence Between Debug and Inspect Commands
- F Sample Debug Sessions
- Glossary
- Index
Debug Commands
Debug Manual—421921-003
4-37
Display Register Contents
Syntax for a device other than a disk:
[ node.]{device-name[.qualifier ] }
{ldev-number }
Syntax for a named process:
[ node.]process-name[:seq-no][.qual-1[.qual-2] ]
Syntax for an unnamed process:
[ node.]$:cpu:pin:seq-no
For syntax descriptions of these process and device names, see the Guardian
Procedure Calls Reference Manual.
Examples Specific to Debugging in TNS
EXECUTION MODE = TNS
050,03,00020-d *
S=%000060 P=%000177 E=%000207 L=%000023 SP=UC.%00
ENV IS: T CCG RP7
EXAMPLE_FILL_ARRAY + %000073
*REG* %000010 %000055 %000000 %000066 %000000 %000000 %000140 %000166
050,03,00020-d e
ENV IS: T CCG RP7
050,03,00020-d sp
SPACEID: UC.%00
050,03,00020-d r7
*REG*: %000166