Debug Manual

Debug Commands
Debug Manual—421921-003
4-64
PMAP Command (Accelerated Programs)
PMAP Command (Accelerated Programs)
The PMAP command prints corresponding blocks of TNS and RISC instruction code.
The form of the PMAP command is:
address
is a code address. For more information, see Address Syntax on page 3-12. The
address-mode parameters allowed for a code address are as follows:
•
UC, UL, SL, and C address modes are allowed while in nonprivileged mode.
N address mode is also allowed for addresses in any native code space and
for addresses in accelerated code spaces UC, UL, and SL.
•
Any address mode appropriate for the processor is allowed while in privileged
mode.
count
is an expression representing the number of instructions to be displayed. Valid
values for count are integers. Debug displays the minimum number of blocks of
instructions that includes the count number of instructions.
[OUT] output-dev
specifies where the display is directed. Debug output can be directed to an output
device, a process, or a spooler collector. Debug output cannot be directed to a disk
file. If you omit output-dev, Debug assumes the home terminal.
output-dev has these formats.
Syntax for a device other than a disk:
[ node.]{device-name[.qualifier ] }
{ldev-number }
Syntax for a named process:
[ node.]process-name[:seq-no][.qual-1[.qual-2] ]
Syntax for an unnamed process:
[ node.]$:cpu:pin:seq-no
•
For syntax descriptions of these process and device names, see the Guardian
Procedure Calls Reference Manual.
Considerations
•
The PMAP command is allowed only on TNS or RISC code in accelerated program
areas.
PMAP address [ , count ] [ , [ OUT ] output-dev ]