Debug Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction
- Execution Modes on TNS/R Systems
- What User Access Is Required for Debugging
- How to Make a Process Enter Debug
- How to Select Debug as the Debugger
- Why a Process Enters Debug
- How to Determine Process State on a Trap or Signal
- Ending a Debug Session
- What Appears in the Debug Header Message
- How to Use Debug
- How Debug Breakpoints Work
- 2 Using Debug on TNS/R Processors
- 3 Debug Command Overview
- 4 Debug Commands
- Command Summary
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command (TNS/R Native and OSS Processes)
- INSPECT Command
- LMAP Command
- M Command
- MH Command (TNS/R Native and OSS Processes)
- P[AUSE] Command
- PMAP Command (Accelerated Programs)
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- A Error Messages
- B ASCII Character Set
- C Command Syntax Summary
- Register Syntax
- Expression Syntax
- Address Syntax
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command
- INSPECT Command
- LMAP Command
- M Command
- MH Command
- Output-Device Syntax
- P[AUSE] Command
- PMAP Command
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- D Session Boundaries
- E Correspondence Between Debug and Inspect Commands
- F Sample Debug Sessions
- Glossary
- Index
Error Messages
Debug Manual—421921-003
A-5
19
19
Cause. The specified PIN is not valid. You did not specify the correct address, or the
PIN is in a different processor than where you are debugging.
Effect. The command is not executed.
Recovery. Verify that the PIN is in the processor where you are debugging, or make
sure that the address is correct.
20
Cause. The specified number was greater than what the command expected.
Effect. The command is not executed.
Recovery. Specify a value that can fit in a 16-bit word and try again.
21
Cause. Either an incorrect syntax was provided or the end of a command was
expected.
Effect. The command is not executed.
Recovery. Look over the syntax for the command in the help line and make sure that
you provide the correct syntax.
22
Cause. An attempt was made to specify an output device that is the same as the one
that is currently being used.
Effect. The command is not executed.
Recovery. Make sure that the specified output device is not the same as the terminal
device that is currently being used.
Invalid PIN.
Specified number is greater than 0xFFFF.
Incorrect syntax or end of command expected.
Internal error: current output device matches new output device.