Debug Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction
- Execution Modes on TNS/R Systems
- What User Access Is Required for Debugging
- How to Make a Process Enter Debug
- How to Select Debug as the Debugger
- Why a Process Enters Debug
- How to Determine Process State on a Trap or Signal
- Ending a Debug Session
- What Appears in the Debug Header Message
- How to Use Debug
- How Debug Breakpoints Work
- 2 Using Debug on TNS/R Processors
- 3 Debug Command Overview
- 4 Debug Commands
- Command Summary
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command (TNS/R Native and OSS Processes)
- INSPECT Command
- LMAP Command
- M Command
- MH Command (TNS/R Native and OSS Processes)
- P[AUSE] Command
- PMAP Command (Accelerated Programs)
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- A Error Messages
- B ASCII Character Set
- C Command Syntax Summary
- Register Syntax
- Expression Syntax
- Address Syntax
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command
- INSPECT Command
- LMAP Command
- M Command
- MH Command
- Output-Device Syntax
- P[AUSE] Command
- PMAP Command
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- D Session Boundaries
- E Correspondence Between Debug and Inspect Commands
- F Sample Debug Sessions
- Glossary
- Index
Error Messages
Debug Manual—421921-003
A-11
44
44
Cause. The HIST_FORMAT_ function returned an internal error when the LMAP
command was used.
Effect. The command either might not be executed or it might be partially executed.
Recovery. Check the address assigned to the LMAP command. If the address is not
valid, make sure that you specify a valid address. If the address is valid, contact your
service provider.
45
Cause. Debug encountered an error when attempting to turn off the privileged mode.
Effect. The command is not executed.
Recovery. Check the PRV setting with the? command; it might already be set to OFF.
46
Cause. Debug was not able to turn on the privileged mode. You must be the super ID
(255, 255) in order to use the privileged mode.
Effect. The command is not executed.
Recovery. If you are a privileged user, log on the system as the super ID (255,255)
and try the PRV ON command again.
47
Cause. One of the possible values was not specified.
Effect. The command is not executed.
Recovery. Specify one of the values listed in the message text and try again.
Internal error: HIST_FORMAT_ error:error-number.
Unsuccessful turning OFF of PRV.
Unsuccessful turning ON of PRV.
Expecting one of the following: =, <>, <, >, or ?.