Debug Manual
Table Of Contents
- What’s New in This Manual
- About This Manual
- 1 Introduction
- Execution Modes on TNS/R Systems
- What User Access Is Required for Debugging
- How to Make a Process Enter Debug
- How to Select Debug as the Debugger
- Why a Process Enters Debug
- How to Determine Process State on a Trap or Signal
- Ending a Debug Session
- What Appears in the Debug Header Message
- How to Use Debug
- How Debug Breakpoints Work
- 2 Using Debug on TNS/R Processors
- 3 Debug Command Overview
- 4 Debug Commands
- Command Summary
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command (TNS/R Native and OSS Processes)
- INSPECT Command
- LMAP Command
- M Command
- MH Command (TNS/R Native and OSS Processes)
- P[AUSE] Command
- PMAP Command (Accelerated Programs)
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- A Error Messages
- B ASCII Character Set
- C Command Syntax Summary
- Register Syntax
- Expression Syntax
- Address Syntax
- A Command
- AMAP Command
- B Command
- BASE Command
- BM Command
- C Command
- CM Command
- D Command
- DJ Command
- DN Command
- EX[IT] Command
- F[ILES] Command
- FC Command
- FN Command
- FNL Command
- FREEZE Command
- HALT Command
- H[ELP] Command
- I Command
- IH Command
- INSPECT Command
- LMAP Command
- M Command
- MH Command
- Output-Device Syntax
- P[AUSE] Command
- PMAP Command
- PRV Command
- R Command
- S[TOP] Command
- T Command
- V Command
- VQ Command
- VQA Command
- = Command
- ? Command
- D Session Boundaries
- E Correspondence Between Debug and Inspect Commands
- F Sample Debug Sessions
- Glossary
- Index
Error Messages
Debug Manual—421921-003
A-23
92
92
Cause. The PMAP command encountered an error indicating that ending-value of the
TNS address was zero.
Effect. The command might be partially executed.
Recovery. Make sure that the address and the length specified for the PMAP
command are correct.
93
Cause. You attempted to use an Inspect command while vectored to another PIN.
Effect. None.
Recovery. If you want to use Inspect commands, you must vector back to the PIN
where you started from by entering the V command with no parameters.
94
Cause. The attempt to switch to the Inspect debugger failed.
Effect. None.
Recovery. Make sure that DMON is running in the processor where you are working.
95
Cause. The BASE command indicated that the user did not specify one of the
expected options (standard, octal, decimal, hexadecimal, S, O, D, or H).
Effect. The specified command is not executed.
Recovery. Specify one of the given options and try again.
TNS ending address is zero.
Cannot access Inspect while vectored to another PIN.
Attempt to switch to Inspect failed.
Expecting: standard, octal, decimal, hexadecimal, S, O, D, or H.