Debug Manual

Debug Commands
Debug Manual—421921-003
4-2
Command Summary
H[ELP] Command Display help information about Debug
commands
4-51
I Command Display data as instruction code 4-52
IH Command
(TNS/R Native and
OSS Processes)
Display information about signal handling 4-54
INSPECT
Command
Transfer control to the Inspect debugger 4-55
LMAP Command Display the name of the procedure, and
the offset from the base of the
procedure, where a specified address
lies
4-57
M Command Modify data, registers, or space identifier 4-58
MH Command
(TNS/R Native and
OSS Processes)
Modify signal handling 4-62
P[AUSE]
Command
Pause (suspend) process for specified
period
4-63
PMAP Command
(Accelerated
Programs)
Print corresponding blocks of
accelerated code
4-64
PRV Command Enable or disable privileged debugging 4-65
R Command Resume process execution 4-66
S[TOP] Command Stop process execution 4-67
T Command Display a stack-marker traceback or
procedure-name traceback
4-68
V Command
√
Enable access to other address spaces 4-71
VQ Command Change selectable data segment
currently viewed by Debug
4-72
VQA Command
√
Set the current selectable data segment
to the specified absolute segment
number
4-73
= Command Compute and display value of an
expression
4-73
? Command Display identifiers for the current code
segment and for the selectable data
segment that is currently in use
4-75
Table 4-1. Debug Command Summary (page 2 of 2)
Command
Priv
Only Purpose Page