Distributed Name Service (DNS) Management Operations Manual

ADD SSTYPE
The DNSCOM Commands
7–40 31258 Tandem Computers Incorporated
ADD SSTYPE The ADD SSTYPE command defines a subsystem-object type. This command may be
used only in definition mode. For more information about using the ADD command,
see “Notes About ADD Commands” at the beginning of this section.
ADD [ SSTYPE ] ssobject type
[ LIKE an ssobject type [ IN subsystem ] [ at-part ] ]
[ , parameter ] ...
where at-part is:
AT { \ system | name manager }
SSTYPE
may be omitted if the default object is SSTYPE.
ssobject type
is the subsystem-object type name being added.
an ssobject type
is some other subsystem-object type whose creation values are to be used,
overriding those of a previous SET SSTYPE command.
subsystem
is the name of a subsystem where an ssobject type is located. This may be
omitted if an ssobject type is unique on the local system.
{ \ system | name manager }
is a system or name manager where an ssobject type is defined. If omitted,
the current name manager is assumed.
\ system is a Guardian 90 system name. It designates a node other than the
current system for processing the command. name manager designates a
configuration other than the current one.