Distributed Systems Network Management (DSNM) Subsystem Interface Development Guide

FC Command
7-6
109759—Distributed Systems Network Management (DSNM) Subsystem Interface
Development Guide
DSNMCom: The I Process Test Utility
Considerations
•
The DSNMCom process terminates when it reads the end of file (EOF) of an input
file: you do not have to end an input command file with an EXIT command.
•
Entering Ctrl/Y at the terminal is the same as EOF. If you type Ctrl/Y at the
DSNMCom prompt, DSNMCom terminates.
•
The DSNMCom QUIT command is synonymous with the EXIT command.
FC Command
FC (fix command) allows you to modify and resubmit the last command line entered.
The FC command is not recognized if preceded by a period (.).
Considerations
The FC subcommands (R, I, and D) are the same as those used for the TACL FC
command. See the TACL Reference Manual for further description.
HELP Command
The HELP command displays DSNMCom command and parameter names or the syntax
of a particular DSNMCom command. It also provides limited usage information for
commands and parameters.
OUT filename
is the output device for the listing. If omitted, the output is sent to your home
terminal.
command
is the name of the DSNMCom command whose syntax you want to see.
paramname
is the name of the DSNMCom parameter about which you want to see information.
The DSNMCom parameters are listed in the “SET Command” subsection, later in
this section.
FC
HELP [ / OUT filename / ] [ command or paramname ]