Distributed Systems Network Management (DSNM) Subsystem Interface Development Guide

DSNMCom: The I Process Test Utility
Distributed Systems Network Management (DSNM) Subsystem Interface Development
Guide—109759 7-7
SET Command
OPEN Command
The OPEN command opens the specified process.
$process-name
is the name of the process to which you want to send DSNM commands.
Consideration
A previously opened process (if any) is closed upon successful completion of the OPEN
command.
QUIT Command
The QUIT command closes all files and terminates DSNMCom; it is synonymous with
the EXIT command.
Consideration
See the EXIT command considerations.
RESET Command
The RESET command returns all settable parameters to their default values. You might
find this command useful to quickly reset all the DSNMCom parameters to their defaults
before resetting just one parameter (for a specific test). For a specific test, use the
RESET command to restore all the default settings, then use the SET command to set a
single parameter.
SET Command
The SET command allows you to set DSNMCom parameters, most of which are
security attributes. The LICENSED, LOGGED-ON, REMOTE, SEND-SECINFO, and
TYPED-OUTPUT parameters can be set to YES, NO, TRUE, FALSE, ON, or OFF.
These security parameters allow you to establish a simulated test environment where
processes and commands appear to have certain characteristics or security attributes.
This allows you to test your I process or server process without establishing an entire
DSNM environment.
OPEN $process-name
QUIT
RESET
SET paramname paramvalue