Distributed Systems Network Management (DSNM) Subsystem Interface Development Guide

DSNM Error Codes
Distributed Systems Network Management (DSNM) Subsystem Interface Development
Guide—109759 B-3
-45 ZDSN^ERR^TKN^REQ
-34 ZDSN^ERR^INTERNAL^ERR
Cause. An internal program error or inconsistency occurred.
Effect. Command terminated abnormally due to an internal DSNM component error,
possibly due to memory corruption.
Recovery. Check the EMS event log for the error reported. Stop the I process and then
start it again. If the error persists, contact your Tandem representative.
-35 ZDSN^ERR^SUBSYSTEM^ERR
Cause. In attempting to execute your command, the subsystem generated an error. The
name of the subsystem appears in the error message.
Effect. The command is executed on all objects except the one for which the error
occurred. The state of the error object is subsystem-dependent.
Recovery. Refer to the subsystem documentation for error information.
-44 ZDSN^ERR^TKN^VAL^INV
Cause. Your command included something invalid in the position where a keyword or
operand is expected.
Effect. Your command is not executed.
Recovery. See Section 2, “DSNM Commands,” for the correct syntax of the command
and reissue it.
-45 ZDSN^ERR^TKN^REQ
Cause. Your command omitted something that is syntactically required.
Effect. Your command is not executed.
Recovery. See Section 2, “DSNM Commands,” for the correct syntax of the command
and reissue it.
Unexpected Error: DSNM Component Error
Subsystem Error
Invalid Token or Operand Value
Required Token or Operand Missing