Distributed Systems Network Management (DSNM) Subsystem Interface Development Guide

-76 ZDSN^ERR^BADCOMMAND
B-6
109759—Distributed Systems Network Management (DSNM) Subsystem Interface
Development Guide
DSNM Error Codes
-76 ZDSN^ERR^BADCOMMAND
Cause. The command is not valid for the subsystem.
Effect. The command is not executed.
Recovery. Refer to the User’s Guide to DSNM Commands for information on which
commands are supported for the subsystem you specified.
-77 ZDSN^ERR^UNSUPPORTED^BY^SUBSYS
Cause. The operation or command modifier is not supported by the subsystem you
specified.
Effect. Your command is not executed.
Recovery. Refer to the User’s Guide to DSNM Commands for information about the
commands supported by the specified subsystem.
-78 ZDSN^ERR^UNSUPPORTED^BY^I
Cause. You attempted to use an operation or command modifier that is not supported by
the DSNM interface.
Effect. Your command is not executed.
Recovery. Refer to the User’s Guide to DSNM Commands for information about the
commands you can use.
-79 ZDSN^ERR^DATA^INTEGRITY
Cause. Arguments are inconsistent or data structures have been corrupted.
Effect. The frame waits for the next event to redispatch the command thread. The
command may yield erroneous results.
Recovery. Stop and restart the I process. If the error persists, contact your Tandem
representative.
Unexpected Error: Invalid Command
Not Supported by Subsystem
Not Supported by DSNM Interface
Unexpected Error: Data Integrity Error