Distributed Systems Network Management (DSNM) Subsystem Interface Development Guide

Distributed Systems Network Management (DSNM) Subsystem Interface Development
Guide—109759 2-1
2
DSNM Commands
Scope of This Section
This section describes the DSNM commands that your subsystem interface process
(I process) must support. It provides syntax descriptions in sufficient detail to allow you
to test the commands in an end-user’s capacity, explains the effect of the valid modifiers
on each command, and defines what the outcome of each command should be. For
complete descriptions and syntax of all DSNM commands, see the User’s Guide to
DSNM Commands.
Command Line Syntax
All DSNM commands, except AGGREGATE, have the same general syntax, which
includes the following information:
•
Command
•
Object specification
•
Modifiers
•
Parameters
The DSNM command syntax is shown below:
Commands
command can be any one of the following:
•
ABORT
•
INFO
•
INQUIRE
•
START
•
STATISTICS
•
STATUS
•
STOP
•
UPDATE
command objectspec [, objectspec ][, modifier ][, parameter ]