DSM/SCM Event Management Programming Manual

Event Messages
DSM/SCM Event Management Programming Manual—529844-003
5-143
4250 ZPHI-EVT-LABEL-TAPE-APPLY
Cause. DSM/SCM is writing an activation package to a labeled tape as the user
requested. Check the system EMS log to see any labeled tape operator messages.
Effect. Informational message only; no corrective action is needed.
Recovery. Informational message only; no corrective action is needed.
4250 ZPHI-EVT-LABEL-TAPE-APPLY
The activation package is on a labeled tape, which the Apply process does not
automatically support. This message reminds you that to perform the Apply, you must
first use Restore to read the activation package from the labeled tape onto the target
system.
Cause. DSM/SCM finished building a configuration, putting its activation package onto
a labeled tape. The Apply process cannot read an activation package directly from a
labeled tape.
Effect. The activation package cannot be applied until it is restored to disk.
Recovery. Use Restore to restore the activation package from the labeled tape onto
the target system, then perform the Apply.
4260 ZPHI-EVT-RUNNING-SYSGEN
System generation is required for the current Build, and DSM/SCM is about to run a
system generation program.
Cause. DSM/SCM is ready to run a system generation program.
Effect. The system generation program is run.
Recovery. Informational message only; no corrective action is needed.
Tokens
Message Text
WARNING: You must restore the labeled Activation Tape onto
the target system and do the apply from disk.
Tokens
None.
Message Text
Running SYSGEN.