DSM/SCM Event Management Programming Manual

Event Messages
DSM/SCM Event Management Programming Manual—529844-003
5-145
4270 ZPHI-EVT-RUNNING-SYSGEN-SIT
Cause. You either used a Gnn.nn RVU to build a configuration for a TNS/E target or
an Hnn.nn RVU to build a configuration for a TNS/R target.
•
A Gnn.nn SUT is intended only for a TNS/R target.
•
An Hnn.nn SUT is intended only for a TNS/E target.
Effect. The Build stops restartable.
Recovery. Cancel the Build request. Check that the processor type for the target
configuration is set correctly in the system maintenance profile. Re-create another
configuration revision using a SUT with the correct RVU.
4270 ZPHI-EVT-RUNNING-SYSGEN-SIT
System generation is required for the current Build, a SIT has been requested, and a
system generation is about to run.
Cause. DSM/SCM is ready to run a system generation program because system
generation is required, and the user has requested a SIT be created. When the
message “SYSGEN COMPLETED FOR DSM/SCM” appears, the SIT creation has
completed as well.
Effect. Informational message only; no corrective action is needed.
Recovery. Informational message only; no corrective action is needed.
4280 ZPHI-EVT-RUNNING-SIT-SYSGEN
System generation is not required for the current Build, but a system generation
program is about to run to create a SIT.
Cause. System generation is not required for the current Build, but a request was
made to create a SIT. In this case, DSM/SCM does not have the necessary files to
create the SIT itself and needs to run a system generation program to create those
files. When the message “SYSGEN COMPLETED FOR DSM/SCM” appears, the SIT
creation has completed as well.
Tokens
Message Text
Running SYSGEN (with SIT creation).
Tokens
None.
Message Text
Running SYSGEN (because of SIT creation).