DSM/SCM Event Management Programming Manual

Event Messages

DSM/SCM Event Management Programming Manual—529844-003

5-173

5080 ZPHI-EVT-NO-SAFEGUARD

No file placement can be done at the target until Safeguard is running.

Cause. The target system is protected by Safeguard, but Safeguard is not running. No

file placement can be performed at the target until Safeguard is running

Effect. The activity stops in a restartable state. No file placement is performed.

Recovery. Either start Safeguard on the target system so that Safeguard can put the

correct protection on the DSM/SCM files, or use the Maintenance Interface to change

the system profile for the target system so that Safeguard protection is no longer

required.

5085 ZPHI-EVT-SAME-PRI-ALT-VOL

DSM/SCM cannot be used with systems where two or more disk volumes have the

same primary volume name and alternate volume name pair.

ZPHI-TKN-PRI-INT-VOL-NM

is the name of the primary volume being shared.

ZPHI-TKN-ALT-INT-VOL-NM

is the name of the alternate volume being shared.

Tokens

None.

Message Text

No file placement performed; SAFEGUARD must be running before

this APPLY or BACKOUT activity can be RESTARTED. Either a)

bring up SAFEGUARD and restart the activity or b) cancel this

activity and use the MI as follows before starting a new

activity--use the host MI (if you performed an APPLY) or the

target MI (if you performed a BACKOUT) to change the

attribute for this targert so that SAFEGUARD protection is no

longer required.

Tokens

ZPHI-TKN-PRI-INT-VOL-NM <1> token-type ZSPI-TYP-DEVICE

ZPHI-TKN-ALT-INT-VOL-NM <2> token-type ZSPI-TYP-DEVICE

Message Text

DSM/SCM cannot continue processing your request. Two disk

volumes may not have the same primary and alternate name pair

<1> <2>. Ensure that you have labelled the disks correctly.