DSM/SCM Event Management Programming Manual

DSM/SCM Event Management Programming Manual—529844-003
C-1
C BACKUP Errors
Table C-1 lists BACKUP errors and provides text descriptions. These errors appear as
the value of ZBRT-TKN-ERROR in the BACKUP event messages described in
Section 6, Event Messages From Other Subsystems. For information on correcting
BACKUP errors, see the Guardian Disk and Tape Utilities Reference Manual.
Table C-1. BACKUP Errors (page 1 of 2)
Error Number Text Description of Error
7500 Not positioned to the beginning of the tape.
7501 A 7-track tape drive cannot be used for BACKUP/RESTORE. Must be a 9-
track drive.
7502 Bad tape format (Bad length for a DP1 tape file label).
7503 Bad tape format (Bad section length in DP2 tape file label).
7504 Bad tape format (Bad length for a DP2 tape file label).
7505 Bad tape format (End-of-file encountered where file label or ending volume
label expected).
7506 Checksum error on tape record.
7507 Parity error on tape record.
7508 Bad tape format (Record found that is not a file label or an ending volume
label).
7509 Bad tape format (Ending volume label does not match beginning volume
label).
7510 Bad tape format (No files on tape).
7511 Bad tape format (Bad continuation indicator for ending volume label).
7512 Bad tape format (Bad continuation indicator for beginning volume label).
7513 Bad tape format (End-of-file encountered where continued data block
expected).
7514 Tape drive does not support density selection.
7515 Bad tape format (End-of-file encountered where beginning volume label
expected.
7516 Unable to read beginning volume label (parity error).
7517 This BACKUP set is not allowed to be more than one tape. Rerun with a
larger tape or fewer files.
7518 End of tape encountered near the beginning of the tape.
7519 Tape verify encountered end-of-file where beginning or ending volume label
expected.
7520 Tape verify encountered ending volume label where a file label was
expected.
7521 Tape verify found problem with beginning volume label.