DSM/SCM Event Management Programming Manual

Event Messages

DSM/SCM Event Management Programming Manual—529844-003

5-32

1020 ZPHI-EVT-ACT-STOPPED

ZPHI-TKN-ACT-STOP-CD

is the stopped status of the activity. Possible values and the statuses they

represent are:

restartable. Correct error, RESTART activity

The DSM/SCM activity stopped because of an error and can be restarted after

the error condition is corrected.

non restartable. Correct error, CANCEL activity

The DSM/SCM activity stopped because of an error and cannot be restarted.

The activity must therefore be cancelled.

cancelled restartable. Correct error, RESTART activity

A planner or operator cancelled the activity. The activity stopped while it was

being cancelled. It can be restarted after the error condition is corrected.

cancelled non restartable. Correct error, CANCEL activity

A planner or operator cancelled the activity. The activity stopped while it was

being cancelled. It cannot be restarted. The activity must therefore be

cancelled.

Cause. An error during the specified activity caused processing to stop. The error is

reported in preceding messages. This informational message indicates the stopped

status of the activity.

Effect. Processing stops.

Recovery. Check the error code returned in the preceding message. For recovery

action, see the description of the error in this section. If the status is restartable, the

operator should correct the error and restart the activity.

If the status is nonrestartable, correct the error and cancel the activity. You can then

resubmit the request if necessary.

Use the Maintenance Interface to delete nonrestartable requests. (See the DSM/SCM