DSM/SCM Messages Manual

DSM/SCM EMS Messages
DSM/SCM Messages Manual—529845-006
5-14
2031
If the error is a warning, the operator or planner might need to decide if corrective
action is needed. If the error is restartable, correct the error and restart the activity.
If the filename was $EMSLOGF.ILEERROR, the server process could not send an
EMS message out to the DSM/SCM EMS collector. Instead, this error was reported
back to the Schedule Manager on behalf of the server that could not send out the
message. This is most likely caused by an internal code error where an EMS message
routine was not called. Performing a trace will help identify the faulty code to
development.
2031
error-type
indicates whether the error is restartable or a warning. Possible values:
Restartable error Warning
file-error
is the file-system error that occurred. For file-system error definitions, see
Section 7, File-System Errors.
action-name
is the name of the procedure or action during which the error occurred. Possible
values:
AWAITIO OPEN
CLOSE POSITION
CONTROL PUP Listlabel
CREATE READ
DELETE READUPDATE
DEVICEINFO2 RENAME
DISKINFO REPLY
DSC SPI command CONFIG Safeguard access check
DSC SPI command LISTDEV Safeguard command ADD FILE
EDITREAD Safeguard command DELETE FILE
EDITREADINIT SETMODE
FILEINFO STOP
FILEINQUIRE TAPEMOUNT
FUP Dup UNLOCK
NEWPROCESS WRITE
NEXTFILENAME WRITEREAD
process-name
is the process name in the internal format of the process where the error occurred.
error-type file-error on action-name of process
process-name , file filename . If error type is Warning, decide
upon corrective action. If error type is Restartable, correct
error and RESTART activity.