DSM/SCM Messages Manual

DSM/SCM EMS Messages
DSM/SCM Messages Manual—529845-006
5-100
5024
5024
filename
is the name of the file manufactured by a system generation program.
Cause. DSM/SCM detected that the new file manufactured by a system generation
program is different from the one in the executing SYS nn . OVERRIDE parameters
were specified to ignore the difference.
Effect. The Apply continues.
Recovery. No action is required.
5025
sysnn-type
is the current configuration SYS nn .
sysnn-num
is the octal number of the current configuration SYS nn .
Cause. An Apply activity could not finish because it tried to replace the current
configuration SYS nn .
Effect. The activity stops in a restartable state.
Recovery. The recovery steps depend on the situation:
•
Perform a system load from a different SYS nn ; then restart the activity.
•
Cancel this Apply; then start a new Apply request specifying a different target
SYS nn.
OVERRIDE-SYSNN specified. File filename has changed and will
be replaced in the running SYSnn.
Cannot proceed, cannot replace sysnn-type SYSnn sysnn-num .
Either coldload a different SYSnn and RESTART the activity or
CANCEL this APPLY and start a new APPLY specifying a
different target SYSnn.