DSM/SCM Messages Manual

Target Interface Messages
DSM/SCM Messages Manual—529845-006
2-6
Warning and Error Messages
Cause. You pressed Page Up or Page Down, but there are no previous or additional
items (targets, subvolumes, messages, or instructions) to list.
Effect. DSM/SCM warns that you are at the beginning or end of a list.
Recovery. Informational message only; no corrective action is needed.
Cause. No previous configuration exists for this target. Therefore, you cannot back out
the current configuration or view the instructions for a previous configuration.
Effect. DSM/SCM does not perform the backout or get instructions request.
Recovery. Informational message only; no corrective action is needed.
Cause. DSM/SCM detected an error in the Pathway subsystem.
Effect. Depending on the error, the request stops in either a restartable or
nonrestartable state.
Recovery. Review the messages on your Pathway subsystem hometerm (or log, if
you have defined one) to determine the problem. For the appropriate action, see the
error messages section of the TS/MP Management Programming Manual .
Cause. You pressed F3 (Restart) or F6 (Cancel) after the request stopped in a
nonrestartable state.
Effect. DSM/SCM does not let you restart or cancel a request that is in a
nonrestartable state.
Recovery. Ask your database administrator to delete the request from the database.
No more items to list.
No previous SYSnn available. Cannot BACKOUT or GET PREVIEW.
Pathway error. See error log and Pathway manual.
Request is not in a restartable or cancellable state.