DSM/SCM User's Guide

Running CNFGINFO

DSM/SCM User’s Guide — 529846-014

C - 2

Preparing to Run CNFGINFO

To run CNFGINFO, the file CNFGI.EXE must be installed on a PC with a Winsock

connection to a NonStop host system. (See Section 5, Configuring DSM/SCM.) If you

are running CNFGINFO outside DSM/SCM, you must run the server program file

CNFGINFO from the ZDSMSCM subvolume using these parameters: NOWAIT, NAME

$ZPHC, TERM, IN, and OUT. The server will be running if the full DSM/SCM product is

installed and you have run STARTSCM from the ZDSMSCM subvolume.

Before you run CNFGINFO:

1. Place the appropriate product files in a DSV:

2. Check that you have access to the needed A0CINFO files:



You must have read access to view an A0CINFO file. Otherwise, you receive

an error message when you try to open it.



To modify or create an A0CINFO file, you must have read access to the files in

the DSV and read, write, and purge access to the A0CINFO file.

Normally, purge access is required to modify the A0CINFO file. To modify an

A0CINFO file without purge access, set the CNFGINFO-NO-PURGE option to

ON:

> STOPSCM (or STOPCFG)

> PARAM CNFGINFO-NO-PURGE ON

> STARTSCM (or STARTCFG)



Any new A0CINFO files you create have the ownership and security attributes

of the user ID under which you logged on.

Scenario Files to be put in the DSV

Defining a new application (product) All product files

Defining a new revision to your product All product files for the new revision

Defining a base SPR for your product All product files

(A base SPR contains all files for a product

tho

ugh only a

few files might have changed.)

Defining an update SPR for your product Only the changed files