DSM/Tape Catalog Management Programming Manual

Errors
DSM/Tape Catalog Management Programming Manual—520481-003
A-60
5062 ZMCS-ERR-LOGICALCOPYINVALID
5062 ZMCS-ERR-LOGICALCOPYINVALID
The value for LOGICAL must be 1 or 2 for this command.
Cause. The value for LOGICAL was not specified as 1 or 2.
Effect. The command does not execute.
Recovery. Specify a LOGICAL value of either 1 or 2.
5063 ZMCS-ERR-LOGICALCOPYRESET
An attempt was made to reset the value for LOGICAL.
Cause. RESET with a reset value was specified for the LOGICAL option.
Effect. The command does not execute.
Recovery. Use the HELP command to check what is valid for LOGICAL, and specify a
valid value.
5064 ZMCS-ERR-MAXRESPINVALID
The value specified for this token was invalid.
Cause. The ZSPI^TKN^MaxResp token specified in the SPI buffer was not valid.
Effect. The command does not execute.
Recovery. Specify a valid value for the ZSPI^TKN^MaxResp token.
ZSPI-TKN-ERRLIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST
Corresponding MEDIACOM Error Message
LOGICAL must be 1-2.
ZSPI-TKN-ERRLIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST
Corresponding MEDIACOM Error Message
LOGICAL cannot be reset.
ZSPI-TKN-ERRLIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZSPI-TKN-ENDLIST
Corresponding MEDIACOM Error Message
The ZSPI^TKN^MaxResp token must be -1 or greater than zero.