DSM/Tape Catalog Messages Manual

MEDIACOM Warning Messages
DSM/Tape Catalog Messages Manual — 422947-007
12 - 2
Warning Messages 100, 900, and 6306
909
Cause. The requested and actual tape density or tape mode did not match. $ZSVR
selects only those tape drives that support the requested DENSITY/TAPEMODE. If the
tape drive does not support the requested DENSITY/TAPEMODE, the specified tape
volume is not mounted.
Effect. The mount request is unsatisfied, and the operator would not know why the
specified tape was not used.
Recovery. Reject the request and correct the DEFINE to specify
DENSITY/TAPEMODE or specify the correct DENSITY/TAPEMODE, and retry the
operation. If DSM/TAPE CATALOG is not being used (via CLASS TAPECATALOG
DEFINEs), the tape volumes are automatically selected to match the specified
DENSITY or TAPEMODE.
6306
Cause. The LSM tape drive had an old LSM address.
Effect. The old address was altered.
Recovery. None. This is an informational message.
**WARNING 909** - volser ON drive DOES NOT ALLOW REQUESTED
DENSITY/TAPEMODE
**WARNING-6306** The old LSM address was (n1,n2,n3,n4).