DSM/Tape Catalog Messages Manual

MEDIACOM Syntax Error Message
DSM/Tape Catalog Messages Manual 422947-007
2 - 3
Error Numbers 1000 Through 2000
1008
Cause. An unknown node was specified.
Effect. The command does not run.
Recovery. Specify an existing node.
1009
Cause. The creation of a file catalog or volume catalog failed because the logical
name and physical name are on different subvolumes.
Effect. The command does not run.
Recovery. You must specify the same node for both the subvolume and catalog
name.
1010
Cause. An option was specified for the ADD TAPELABEL command that is not
allowed with the SCRATCH option.
Effect. The command does not run.
Recovery. Specify either the TAPEDRIVE, UNLOAD, or OVERRIDE option with the
SCRATCH option.
1012
Cause. An invalid number was specified for this command.
Effect. The command does not run.
Recovery. Verify what is allowed for this command and specify a valid number.
**ERROR-1008** Unknown system.
**ERROR-1009** The SUBVOL system and the catalog system must
match.
**ERROR-1010** Only TAPEDRIVE, UNLOAD, and PROMPT are allowed
with SCRATCH.
**ERROR-1012** Illegal number.