DSM/Tape Catalog Messages Manual

MEDIACOM Syntax Error Message
DSM/Tape Catalog Messages Manual — 422947-007
2 - 22
Error Numbers 1000 Through 2000
1103
Cause. Either the STATUS or TAPEDRIVE parameter was not specified.
Effect. The command does not run.
Recovery. Specify the STATUS or TAPEDRIVE parameter.
1104
Cause. The STATUS parameter was not specified.
Effect. The command does not run.
Recovery. Specify the STATUS parameter.
1105
Cause. More than one tape name was specified when using the COUNT option.
Effect. The command does not run.
Recovery. Specify only one tape name when using the COUNT option.
1106
Cause. This command needs a tape drive specified or a default tape drive set.
Effect. The command does not run.
Recovery. Specify a tape drive in the command or set the environment t
ape drive
default.
**ERROR-1103** STATUS or TAPEDRIVE must be specified.
**ERROR-1104** STATUS must be specified.
**ERROR-1105** Only one tape volume is allowed if COUNT is
specified.
**ERROR-1106** TAPEDRIVE must be specified or defaulted.