DSM/Tape Catalog Operator Interface (MEDIACOM) Manual

MEDIACOM Commands
DSM/Tape Catalog Operator Interface (MEDIACOM) Manual—429828-010
2-70
ALTER TAPEVOLUME Command
(Super Group Only)
POOL pool-name
is the logical name of the pool in which tape-name is cataloged. The default is the
name set by the POOL command. Wild-card characters are permitted in this name.
This parameter is required if no value is available from the MEDIADEFS defaults or
previously set as a MEDIACOM session default. (See the ENV Command on
page 2-89.)
TAPEFORMAT { ALL | BACKUP | ARCHIVE | LONGNAME | NONBACKUP }
controls which tape volumes will be altered:
ALL
Tape volumes of all label types are altered. The default is ALL.
BACKUP
Tape volumes of label type BACKUP are altered (whether their TAPEFORMAT
is ARCHIVE or LONGNAME).
ARCHIVE
Tape volumes of label type BACKUP that were written with the BACKUP
(T9074) or BACKCOPY utilities and that can be read with the RESTORE utility
(T9074) are altered. For more information on TAPEFORMAT, see the Backup
and Restore 2.0 Manual.
LONGNAME
Tape volumes of label type BACKUP that were written with Backup and
Restore 2.0 BACKUP (T9074) and that can be read with Backup and Restore
2.0 RESTORE (T9074) are altered. For more information on TAPEFORMAT,
see the Backup and Restore 2.0 Manual.
NONBACKUP
Tape volumes of label types other than BACKUP are altered.
VOLCAT \node.volume-catalog-name
is the logical name of the volume catalog that owns the pool. The default is the
name set by the VOLCAT command.
Include \node when the volume catalog is not on your current default node.
This parameter is required if no value is available from the MEDIADEFS defaults or
previously set as a MEDIACOM session default (see the ENV Command
on
page 2-89).