DSM/Tape Catalog Operator Interface (MEDIACOM) Manual

MEDIACOM Commands
DSM/Tape Catalog Operator Interface (MEDIACOM) Manual—429828-010
2-141
INFO VOLCAT Command
INFO VOLCAT Command
INFO VOLCAT retrieves this information about a volume catalog:

The logical name

The physical name (where the catalog is located on disk)

The owner

The security level

The volume catalog version
INFO VOLCAT
entered without a volume catalog name and an OUT file, sends information for the
session default volume catalog to your current default output file (usually your
home terminal).
\node
\node.volume-catalog-name
is the logical name of the volume catalog you are interested in. Wild-card
characters are permitted in this name. The default is the volume catalog name set
by the VOLCAT command.
Include \node with the name when the volume catalog is not on your current
default node.
If only \node is specified, information is retrieved for all volume catalogs of the
nodes in the system search list of \node.
This parameter is required if no value is available from the MEDIADEFS defaults or
previously set as a MEDIACOM session default (see the ENV Command
on
page 2-89).
OUT out-file
specifies where the report is displayed or written. You can name a disk file or a
device, such as a printer or terminal. If not given, the information is sent to your
current default output file (usually your home terminal).
INFO VOLCAT [ \node ]
[ [ \node.]volume-catalog-name ]
[ , OUT out-file ]