DSM/Tape Catalog Operator Interface (MEDIACOM) Manual

MEDIACOM Commands
DSM/Tape Catalog Operator Interface (MEDIACOM) Manual—429828-010
2-173
STATUS TAPEMOUNT Command
The detail report format is a vertical list of items, as Figure 2-13 shows. Not every
item is given when a detail report is requested. The number of items varies
depending on the tape processing mode requested (LP, BLP, or NL processing).
Figure 2-13. STATUS TAPEMOUNT Detail Format
Tape Mount number
Open Mode open
Tape Name tname
Action action
Write Protected prot
Label Type label
Pool Name pool
Volume Catalog vcat
Tape Drive $tape
AVR System avr
Tape Use i/o
Density den
Open Exclusion openex
Comment comment
Process Name $proc
Process (CPU,PIN) c,p
Define Class class
Define Name def
Program Name prog
number Message number assigned by $ZSVR.
open Tape label processing mode. The value of open can be:
BLP REQUEST Tape opened for bypass label processing
NL REQUEST Tape opened for no label processing
UNREADABLE Tape label in nonstandard or unreadable
format
tname
Name of the tape being requested in the message.
action The action you must take for processing to continue. The value of action can
be:
ACCEPT or REJECT Issue ACCEPT TAPEMOUNT or
TAPEMOUNT REJECT TAPEMOUNT command.
MOUNT ANY APPROPRIATE Mount any scratch tape from
pool
SCRATCH TAPE named in DEFINE.
MOUNT REQUESTED TAPE Mount
tname.
MOUNT SCRATCH TAPE Mount an uncataloged scratch
tape.
NO ACTION NEEDED No action is needed.