DSM/Tape Catalog Operator Interface (MEDIACOM) Manual

MEDIACOM Commands
DSM/Tape Catalog Operator Interface (MEDIACOM) Manual—429828-010
2-55
ALTER TAPEDRIVE Command (Super Group Only)
ON
The request must be approved with an ACCEPT TAPEMOUNT command. The
default is ON.
OFF
No approval is necessary.
RESET BLPCHECK
changes the current setting for $tape to ON.
LSM drive-address
associates a tape drive in an LSM with $tape. Specify drive-address in this
format:
( ACS-id, LSM-id, panel-id, drive-id )
ACS-id
is a number in the range 0 through 126 that identifies a group of LSMs
connected to form one tape library.
LSM-id
is a number in the range 0 through 15 that identifies one LSM of the tape
library.
panel-id
is a number in the range 0 through 19 that identifies which panel of the LSM
contains the tape drive.
drive-id
is a number in the range 0 through 15 that identifies the tape drive of panel.
RESET LSM
removes the current LSM tape drive address for $tape.
NLCHECK { ON | OFF }
applies to no label processing only:
ON
The request must be approved with an ACCEPT TAPEMOUNT command. The
default is ON.
Note. In RVUs prior to D42, the drive-id number is restricted to the range of 0
through 3.