EM3270 Manual

EMCOM Messages
Tandem EM3270 Manual—110332 D-5
EMCOM Messages
STATUS - *1057* TERMINALS STOPPED
Acknowledgment of the execution of a STOP * command.
ERROR - *1058* TERMINAL CAPACITY EXCEEDED
An attempt was made to ADD or RUN more than 50 terminals.
ERROR - *1059* NEWPROCESS ERROR: error-number,
PROGRAM: object-file name
A NEWPROCESS creation failed as a result of an X command.
ERROR - *1060* PROCESS I/O ERROR: file-error-number
An error was detected during communication with a process created by an X
command.
ERROR - *1061* UNSUPPORTED PARAMETER
The NOWAIT, TERM, LIB, SWAP, and INSPECT parameters are not supported by
the X command.
ERROR - *1062* INVALID MEM VALUE
The MEM value in an X command must fall between 1 and 64, inclusive.
ERROR - *1063* MISSING MEM VALUE
The MEM value in an X command was not present.
ERROR - *1064* PROGRAM ABENDED
The program run with an X command terminated abnormally.
ERROR - *1065* TERMINAL ALREADY STOPPED
An attempt was made to stop a terminal that was not running.
ERROR - *1066* INVALID VOLUME NAME
An invalid volume name was specified.
ERROR - *1067* INVALID SUBVOLUME NAME
An invalid subvolume name was specified.
ERROR - *1068* NO SUCH SYSTEM
The specified system name is not defined in the network.
ERROR - *1069* INVALID PARAMETER
The specified parameter is not valid (see Section 4, “EM3270 Emulator Command
Set”).
ERROR - *1070* MISSING PARAMETER
A required parameter was not specified.