EM3270 Manual

EMCOM Messages
D-6 110332—Tandem EM3270 Manual
EMCOM Messages
ERROR - *1071* INVALID OBJECT TYPE
An unrecognized parameter or an object type other than DEVICE or PROCESS was
entered.
ERROR - *1072* ILLEGAL OR MISSING DELIMITER
An expected delimiter is either missing or incorrectly entered.
ERROR - *1073* ',' EXPECTED
A comma was expected and was not found.
ERROR - *1074* MISSING TIMEOUT VALUE
A timeout value was not specified.
ERROR - *1075* DEVICE CONFIGURED AS PRINTER
A parameter allowed only with CRT devices was specified.
ERROR - *1076* DEVICE CONFIGURED AS CRT
A parameter allowed only with printers was specified.
ERROR - *1077* UNABLE TO PAUSE IN NON-INTERACTIVE MODE
An error occurred during the PAUSE operation in noninteractive mode.
ERROR - *1078* INVALID DELAY TIME
The delay parameter for the PAUSE command must be a positive integer value.
ERROR - *1079* ALL PATHS TO SYSTEM ARE DOWN
A system was specified to which there are no communication links available.
WARN - *1080* TASK NOT STARTED
The attempted operation failed due to an inactive task.
ERROR - *1081* TERMINAL ALTERED
The terminal configuration has been changed.
ERROR - *1082* TERMINAL DRAIN IN PROGRESS
The terminal STOP command has been sent to the EM3270 emulator and the
terminal will stop as soon as the Tandem application closes it.
ERROR - *1083* INTERACTIVE MODE ENABLED
The interactive mode is enabled by activating the BREAK key while in
noninteractive mode.
ERROR - *1084* INVALID TASK NUMBER
An invalid task number was entered.