EM3270 Manual

Sample Host Configurations
Tandem EM3270 Manual—110332 K-5
SNAX/XF Configuration for IBM 5250 Hosts
SNAX/XF Configuration for IBM 5250 Hosts
A sample SCF input file to configure a SNAX/SF secondary line as a model 5294
controller to an IBM AS/400 system is shown below:
assume line $snas1
add line $snas1, station secondary, maxlus 20, &
characterset ebcdic, duplex full, &
iopages 0
add pu #pu1, type (13,1), recsize 265, maxlus 4, &
address 193, puidblk %h045, puidnum %h000c1
add lu #lu1, type (14,0), puname #pu1, recsize 1024, &
ludisabled on, protocol snalu, address 1
add lu #lu2, type (14,0), puname #pu1, recsize 1024, &
ludisabled on, protocol snalu, address 2
add lu #lu3, type (14,0), puname #pu1, recsize 1024, &
ludisabled on, protocol snalu, address 3
add lu #lu4, type (14,0), puname #pu1, recsize 1024, &
ludisabled on, protocol snalu, address 4
start, sub all
Note that in the PU definition the PUIDBLK parameter identifies the AS/400 controller
type as follows:
In addition, the PUIDNUM contains the PU address of the controller that the Tandem
system is emulating. In the above example, the controller PU address is 193 (%hC1).
For more information, refer to “EXCHID” in the IBM publication, AS/400
Communications Configuration Reference Manual, SC41-0001.
The line configuration parameters to connect an AS/400 to a Tandem system using a
9600-baud modem eliminator are shown below:
Line description . . . . . . . . . : TANDMLIN
Option . . . . . . . . . . . . . . : *BASIC
Category of line . . . . . . . . . : *SDLC
Resource names . . . . . . . . . . : LIN051
Online at IPL . . . . . . . . . . : *YES
Data link role . . . . . . . . . . : *PRI
Physical interface . . . . . . . . : *RS232V24
Connection type . . . . . . . . . : *NONSWTPP
Switched network backup . . . . . : *NO
Exchange identifier . . . . . . . : 05620214
NRZI data encoding . . . . . . . . : *NO
Maximum controllers . . . . . . . : 1
Clocking . . . . . . . . . . . . . : *MODEM
Line speed . . . . . . . . . . . . : 9600
Modem type supported . . . . . . . : *NORMAL
Modem data rate select . . . . . . : *FULL
Controller Type
PUIDBLK Value
5251 %h020
5294 %h045
5394 %h05F